Huawei Quidway S9300

Procedure
l Run the display bgp [ vpnv4 vpn-instance vpn-instance-name ] peer [ ipv4-address |
group-name ] verbose command on the RR to view information about the peers of the BGP
VPN instance on the RR.
l Run the display bgp peer [ ipv4-address| group-name ] verbose command on the client
CE to view the BGP peers.
l Run the display bgp vpnv4 all routing-table peer peer-ipv4-address { advertised-
routes | received-routes } [ statistics ] command to view information about the VPNv4
routes received from the peer or the VPNv4 routes advertised to the peer.
l Run the display bgp peer peer-ipv4-address { advertised-routes | received-routes }
[ statistics ] command to view information about the routes received from the peer or the
routes advertised to the peer.
l Run the display bgp vpnv4 vpn-instance vpn-instance-namegroup [ group-name ]
command on the RR to view information about the VPNv4 peer group.
l Run the display bgp group [ group-name ] command on the CE to view information about
the VPNv4 peer group.
----End
Example
If the configurations are successful,
l You can find that the status of the MP-IBGP connections between the RR and all client
CEs is Established after running the display bgp vpnv4 all peer command on the RR.
l You can find that the status of the IBGP connections between the RR and all client CEs is
Established after running the display bgp peer command on the client CE.
l You can view the routing information advertised by the RR to the client CE or the routing
information advertised by the client CE to the RR after running the display bgp vpnv4
all routing-table peer command on the RR.
l You can view the routing information advertised by the client CE to the RR and the routing
information advertised by the RR to the client CE after running the display bgp peer peer-
ipv4-address { advertised-routes | received-routes } [ statistics ] command on the client
CE.
l If the peer group is configured, you can view information about the group members and
find that the status of the BGP connections between the RR and the group members is
Established after running the display bgp vpnv4 all group command on the RR.
3.13 Maintaining the BGP/MPLS IP VPN
This section describes how to view VPN information and debug the VPNs.
3.13.1 Displaying BGP/MPLS IP VPN Information
3.13.2 Checking the Network Connectivity and Reachability
3.13.3 Clearing BGP Statistics of VPN Instance
3.13.4 Resetting BGP Connections
3.13.5 Debugging the BGP/MPLS IP VPN
3 BGP/MPLS IP VPN Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3-52 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)