Huawei Quidway S9300

No. Data
2 IP address of the destination of L2VC and VC ID
3 Name of the tunnel policy
5.5.2 Enabling MPLS L2VPN
Context
Before configuring an MPLS L2VC, you must enable MPLS L2VPN.
Do as follows on the PEs at both ends of a PW.
Procedure
Step 1 Run:
system-view
The system view of the PE is displayed.
Step 2 Run:
mpls l2vpn
MPLS L2VPN is enabled.
----End
5.5.3 Creating a Dynamic PW
Context
Do as follows on the U-PEs.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The AC interface view is displayed.
Step 3 Run:
mpls l2vc { ip-address | pw-template pw-template-name }
*
vc-id [ group-id group-
id ] [ [ control-word | no-control-word ] | [ raw | tagged ] | [ mtu mtu-value ]
tunnel-policy policy-name]
*
[ secondary ]
The dynamic PW is created.
5 PWE3 Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
5-18 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)