Huawei Quidway S9300

Procedure
l Run the undo shutdown command to enable a VSI.
l Run the shutdown command to disable a VSI.
----End
Example
Regarding the requirements of service management such as service commissioning and service
suspension, you can temporarily shut down a VSI, and then add, delete or adjust the VSI function.
The shutdown command affects PW connections in a VSI. After the command is run, the AC
is Administratively Down and the Layer 2 forwarding table is deleted.
6.10.6 Clearing MAC Address Entries
Context
CAUTION
After MAC address entries are cleared, the entries cannot be restored. So, confirm the action
before you clear the entries.
Procedure
l Run the undo mac-address mac-address vsi vsi-name command to clear the MAC address
entries in a VSI.
l Run the undo mac-address { dynamic | static | blackhole | all } command to clear the
dynamic, static, blackhole, or all the MAC address entries.
----End
6.11 Configuration Examples
This section provides several configuration examples of VPLS.
6.11.1 Example for Configuring Martini VPLS
6.11.2 Example for Configuring Kompella VPLS
6.11.3 Example for Configuring LDP HVPLS
6.11.4 Example for Configuring Static VLLs to Access a VPLS Network
6.11.5 Example for Configuring Inter-AS Martini VPLS Option A
6.11.6 Example for Configuring Inter-AS Kompella VPLS Option A
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-37