The system view is displayed.
2. Run:
bgp as-number
The BGP view is displayed.
3. Run:
peer peer-ipv4-address as-number as-number
The client PE is configured as the BGP peer of the RR.
4. Run:
peer peer-ipv4-address connect-interface interface-type interface-number
The interface for establishing the TCP connection is configured. The IP address of the
interface must be the same as the MPLS LSR ID. It is recommended that you specify
a loopback interface to establish the TCP connection.
5. Run:
ipv4-family vpnv4
The BGP VPNv4 address family view is displayed.
6. Run:
peer peer-ipv4-address enable
The function of exchanging VPNv4 routes between the client PE and the RR is
enabled.
----End
3.11.4 Configuring Route Reflection for BGPVPNv4 Routes
Context
Do as follows on the RR.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
ipv4-family vpnv4
The BGP VPNv4 address family view is displayed.
Step 4 Enable the route reflection for BGP VPNv4 routes on the RR:
l If the RR establishes the MP-IBGP connection with the peer group consisting of all client
PEs, run the peer { group-name | peer-ipv4-address } reflect-client command to enable the
route reflection.
3 BGP/MPLS IP VPN Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3-46 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)
To Next Page
Loading...
