Postrequisite
NOTE
l A static LSP is unidirectional. Thus, two static LSPs in opposite directions must be established between
the UPE and the SPE.
l If a P device resides between the UPE and the SPE, run the static-lsp transit command on the P device
to configure a transit node for the static LSP.
6.6.3 Configuring a UPE to Access an SPE Through a Static VLL
Context
Do as follows on the UPE.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Enter the interface view.
1. Run:
vlan vlan-id
A VLAN is created and the VLAN view is displayed.
2. Run:
quit
Return to the system view.
3. Run:
interface vlanif vlan-id
A VLANIF interface is created and the VLANIF interface view is displayed.
Step 3 Run:
mpls static-l2vc destination dest-ip-addr transmit-vpn-label transmit-label-value
receive-vpn-label receive-label-value [ tunnel-policy tnl-policy-name | [ control-
word | no-control-word ] | [ raw | tagged ] ]
*
A static VC is created between the UPE and the SPE.
----End
6.6.4 Binding a Static VLL to a VSI on an SPE
Context
Do as follows on the SPE.
Procedure
Step 1 Run:
system-view
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-23
To Next Page
Loading...
