TIP
MPLS L2VPN need not be enabled on the Ps.
When you configure the Ps, specify the IP address of the next hop if the outgoing
interface is not a P2P interface (such as an Ethernet interface).
----End
4.3.5 Checking the Configuration
Prerequisite
The configurations of the CCC VLL are complete.
Procedure
l Run the display ccc [ ccc-name | type { local | remote } ] command to view information
about the CCC connection.
l Run the display l2vpn ccc-interface vc-type ccc [ down | up ] command to view
information about the interfaces on the CCC connection.
----End
Example
Run the display ccc command, and you can see that the status of the CCC VC is Up. The
following is an example:
Display information about the local connection
<Quidway> display ccc
total ccc vc : 1
local ccc vc : 1, 1 up
remote ccc vc : 0, 0 up
name: CE1-CE2, type: local, state: up,
intf1: Vlanif11 (up), intf2: Vlanif22 (up)
Information about the local connection is displayed as follows:
<Quidway> display ccc
total ccc vc : 1
local ccc vc : 0, 0 up
remote ccc vc : 1, 1 up
name: ctest, type: remote, state: up,
intf: Vlanif300 (up), in-label: 100 , out-label: 200 , nexthop: 15.15.15.11
Run the display l2vpn ccc-interface vc-type ccc command, and you can see that the VC type
is CCC and the status of the connection is Up. The following is an example:
<Quidway> display l2vpn ccc-interface vc-type all
Total ccc-interface of CCC : 1
up (1), down (0)
Interface Encap Type State VC Type
Vlanif99 vlan up ccc
4.4 Configuring an SVC VLL
This section describes how to configure the SVC VLL, that is, how to transmit L2VPN
information without using signaling protocols.
4 VLL Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
4-10 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)
To Next Page
Loading...
