Huawei Quidway S9300

5.6.3 Checking the Configuration
Prerequisite
The configurations of the PW switching are complete.
Procedure
l Run the display mpls switch-l2vc [ ip-address vc-id encapsulation encapsulation-type |
state { down | up } ] command on the S-PE to view information about PW switching.
----End
Example
Run the display mpls switch-l2vc [ ip-address vc-id encapsulation encapsulation-type| state
{ down | up } ] command, and you can see that the VC status is Up. The following is an example:
<Quidway> display mpls switch-l2vc
Total Switch VC : 1, 1 up, 0 down
*Switch-l2vc type : LDP<---->LDP
Peer IP Address : 5.5.5.9, 1.1.1.9
VC ID : 200, 100
VC Type : VLAN
VC State : up
VC StatusCode |PSN |OAM | FW | |PSN |OAM | FW |
-Local VC :| UP | UP | UP | | UP | UP | UP |
-Remote VC:| UP | UP | UP | | UP | UP | UP |
Session State : up, up
Local/Remote Label : 21504/21504, 21505/21504
Local/Remote MTU : 1500/1500, 1500/1500
Local/Remote Control Word : Enable/Enable, Enable/Enable
Local/Remote VCCV Capability : cw lsp-ping/cw lsp-ping, cw lsp-ping/cw lsp-ping
Switch-l2vc tunnel info :
1 tunnels for peer 5.5.5.9
NO.0 TNL Type : lsp , TNL ID : 0x20006
1 tunnels for peer 1.1.1.9
NO.0 TNL Type : lsp , TNL ID : 0x10002
Create time : 0 days, 0 hours, 13 minutes, 1 seconds
UP time : 0 days, 0 hours, 3 minutes, 58 seconds
Last change time : 0 days, 0 hours, 3 minutes, 58 seconds
5.7 Configuring a Backup PW
In the PW FRR network where CEs are asymmetrically connected, you need to configure backup
PWs. When the master PW is faulty, traffic is switched to the backup PW.
5.7.1 Establishing the Configuration Task
5.7.2 Configuring a Backup PW
5.7.3 Checking the Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 5 PWE3 Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-23