Huawei Quidway S9300

mpls
#
mpls l2vpn
#
vsi bgp1 auto
pwsignal bgp
route-distinguisher 169.1.1.2:1
vpn-target 100:1 import-extcommunity
vpn-target 100:1 export-extcommunity
site 2 range 5 default-offset 0
#
mpls ldp
#
interface Vlanif30
ip address 169.1.1.2 255.255.255.0
mpls
mpls ldp
#
interface Vlanif40
l2 binding vsi bgp1
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 30
port hybrid tagged vlan 30
#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 40
port hybrid tagged vlan 40
#
interface LoopBack1
ip address 3.3.3.9 255.255.255.255
#
bgp 100
peer 1.1.1.9 as-number 100
peer 1.1.1.9 connect-interface LoopBack1
#
vpls-family
policy vpn-target
peer 1.1.1.9 enable
#
ospf 1
area 0.0.0.0
network 3.3.3.9 0.0.0.0
network 169.1.1.0 0.0.0.255
#
return
6.11.3 Example for Configuring LDP HVPLS
Networking Requirements
As shown in Figure 6-7, Site 1, Site 2, and Site 3 belong to the same VPLS; CE1 and CE2 access
the basic VPLS fully-connected network through UPEs and CE3 accesses the network through
a PE.
6 VPLS Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
6-50 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)