Huawei Quidway S9300

The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
peer peer-ipv4-address as-number as-number
The RR is configured as the BGP peer of the client CE.
Step 4 Run:
peer peer-ipv4-address connect-interface interface-type interface-number
The interface for establishing the TCP connection is configured. A loopback interface is
recommended.
Step 5 Run:
ipv4-family unicast
The BGP IPv4 address family view is displayed.
Step 6 Run:
peer peer-ipv4-address enable
The function of exchanging IPv4 routes between the client CE and the RR is enabled.
----End
3.12.3 Configuring the RR to Establish MP-IBGP Connections with
All Client CEs
Context
Choose one of the following schemes to configure the RR to establish MP-IBGP connections
with the client CEs.
Procedure
l Configuring the RR to establish MP-IBGP connections with the peer group
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
The BGP view is displayed.
3. Run:
group group-name [ internal ]
An IBGP peer group is created.
4. Run:
peer ip-address group group-name
The peer is added to the peer group.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 3 BGP/MPLS IP VPN Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-49