6 VPLS Configuration
About This Chapter
This chapter describes the basic principle, configuration procedures, and configuration examples
for VPLS.
6.1 Introduction to VPLS
This section describes the principle of PWE3.
6.2 VPLS Features Supported by the S9300
This section describes the VPLS features supported by the S9300.
6.3 Configuring Kompella VPLS
This section describes how to use BGP as the VPLS signaling to configure Kompella VPLS and
how automatic discovery of VPLS PEs is implemented by configuring VPN targets..
6.4 Configuring Martini VPLS
This section describes how to configure Martini VPLS.
6.5 Configuring LDP HVPLS
This section describes how to configure LDP HVPLS.
6.6 Configuring Static VLLs to Access a VPLS Network
This section describes how to configure static VLLs to access a VPLS network.
6.7 Configuring Inter-AS Martini VPLS
This section describes how to configure inter-AS Martini VPLS.
6.8 Configuring Inter-AS Komeplla VPLS
This section describes how to configure the inter-AS Kompella VPLS.
6.9 Setting Related VPLS Parameters
This section describes how to set related VPLS parameters.
6.10 Maintaining VPLS
This section describes how to maintain VPLS.
6.11 Configuration Examples
This section provides several configuration examples of VPLS.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-1
To Next Page
Loading...
