Huawei Quidway S9300

To Next Page

To Previous Page

Procedure

l Run the debugging mpls l2vpn { all | advertisement | download | error | event | oam-

mapping | reroute | timer | connections [ interface interface-type interface-number ] }

command in the user view to enable the debugging of the VLL.

l Run the debugging bgp update l2vpn [ acl acl-number | ip-prefix ip-prefix-name | peer

peer-ipv4-address ] [ receive | send ] [ verbose ] command in the user view to enable the

debugging of BGP Update messages of the Kompella VLL.

----End

4.11 Configuration Examples

This section provides several examples of VLL configuration.

4.11.1 Example for Configuring a Local CCC Connection

4.11.2 Example for Configuring a Remote CCC Connection

4.11.3 Example for Configuring an SVC VLL

4.11.4 Example for Configuring a Martini VLL

4.11.5 Example for Configuring a Local Kompella VLL

4.11.6 Example for Configuring a Remote Kompella Connection

4.11.7 Example for Configuring the Inter-AS Martini VLL Option A

4.11.8 Example for Configuring the Inter-AS Kompella VLL Option A

4.11.9 Example for Configuring Martini VLL FRR (Asymmetrically Connected CEs)

4.11.10 Example for Configuring Kompella VLL FRR (Asymmetrically Connected CEs)

4.11.1 Example for Configuring a Local CCC Connection

Networking Requirements

As shown in Figure 4-4, the CE is connected to the PE through a GE interface.

A local CCC connection is created between CE1 and CE2.

4 VLL Configuration

Quidway S9300 Terabit Routing Switch

Configuration Guide - VPN

4-36 Huawei Proprietary and Confidential

Issue 03 (2009-08-20)

Other manuals for Huawei Quidway S9300