Static MAC address entries are configured.
Step 4 Run:
mac-address blackhole mac-address vsi vsi-name [ pe-vid pe-vid [ ce-vid ce-vid ]
MAC address blackhole entries are configured.
Step 5 Run:
vsi vsi-name
The VSI view is displayed.
Step 6 Run:
mac-learning { enable | disable }
MAC address learning is enabled or disabled.
Step 7 Run:
mac-learn-style { qualify | unqualify }
The MAC address learning mode is configured.
NOTE
Currently, the S9300 supports only the unqualified mode.
Step 8 Run:
mac-limit { action { discard | forward } | alarm { disable | enable } | maximum max
rate interval }
*
The limit on MAC address learning is configured.
----End
Postrequisite
A physical interface can belong to multiple VLANs at the same time, and multiple VLANIF
interfaces can be bound to the same VSI. That is, a VSI associated with a physical interface can
be bound to multiple VLANs, and a VSI bound to a VLANIF interface can be associated with
multiple physical interfaces. Therefore, you need to specify a physical interface and a VLANIF
interface when configuring static or blackhole MAC address entries for VSIs bound to the
VLANIF interface.
6.9.4 Configuring the Delay for Processing VPLS Events
Context
Do as follows on the PEs at both ends of a PW.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls l2vpn
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-33
To Next Page
Loading...
