Huawei Quidway S9300

mpls lsr-id 4.4.4.9
mpls
#
mpls l2vpn
mpls l2vpn default martini
#
mpls ldp
#
isis 1
network-entity 10.0000.0000.0004.00
#
interface Vlanif40
ip address 30.1.1.2 255.255.255.0
isis enable 1
mpls
mpls ldp
#
interface Vlanif50
mpls l2vc 3.3.3.9 100
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 40
#
interface GigabitEthernet2/0/0
port link-type trunk
port trunk allow-pass vlan 50
#
interface LoopBack0
ip address 4.4.4.9 255.255.255.255
isis enable 1
#
return
l Configuration file of CE2
#
sysname CE2
#
vlan batch 50
#
interface Vlanif 50
ip address 100.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 50
#
return
4.11.8 Example for Configuring the Inter-AS Kompella VLL Option
A
Networking Requirements
As shown in Figure 4-11, the devices on the MPLS backbone network use OSPF as IGP to
realize the communication between the devices in the same AS. The Option A scheme is used
to establish the inter-AS Kompella VLL. The peer ASBR is regarded as the CE.
4 VLL Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
4-76 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)