Huawei Quidway S9300

interface Vlanif50
l2 binding vsi a1
#
interface GigabitEthernet1/0/0
port link-type trunk
port default vlan 40
#
interface GigabitEthernet2/0/0
port link-type trunk
port default vlan 50
#
interface LoopBack1
ip address 4.4.4.4 255.255.255.255
isis enable 1
#
return
l Configuration file of CE2
#
sysname CE2
#
vlan batch 50
#
interface Vlanif50
ip address 10.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 50
#
return
6.11.6 Example for Configuring Inter-AS Kompella VPLS Option A
Networking Requirements
As shown in Figure 6-10, CE1 and CE2 belong to the same VPLS, and access the backbone
network through PE1 in AS 100 and PE2 in AS 200 respectively.
It is required to adopt Option A to implement inter-AS Kompella VPLS. The interfaces that
connect ASBR-PEs serve as AC interfaces to which VSIs are bound, that is, the interfaces are
exclusively used by the VPLS.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-75