No. Data
1 Local ASN and peer ASN
2 Types and numbers of the interfaces used to set up the TCP connection
3 IP address of the peer
3.11.2 Configuring the Client PE to Establish MP-IBGP Connection
with the RR
Context
Do as follows on all client PEs.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
peer peer-ipv4-address as-number as-number
The RR is configured as the BGP peer of the PE.
Step 4 Run:
peer peer-ipv4-address connect-interface interface-type interface-number
The interface for establishing the TCP connection is configured. The IP address of the interface
must be the same as the MPLS LSR ID. It is recommended that you specify a loopback interface
to establish the TCP connection.
Step 5 Run:
ipv4-family vpnv4
The BGP VPNv4 address family view is displayed.
Step 6 Run:
peer peer-ipv4-address enable
The function of exchanging VPNv4 routes between the PE and the RR is enabled.
----End
3 BGP/MPLS IP VPN Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3-44 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)
To Next Page
Loading...
