EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
567 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The system view is displayed.
Step 2 Run:
ip vpn-instance vpn-instance-name
The VPN instance view is displayed.
Step 3 Run:
tnl-policy policy-name
The tunnel policy is applied to the VPN instance.
----End
1.6.5 Checking the Configuration
Prerequisite
The configurations of L3VPN tunnel binding are complete.
Procedure
l Run the display tunnel-policy policy-name command to view the configurations of tunnel
policies.
l Run the display interface tunnel interface-number command to view information about
the bound tunnel interface.
l Run the display ip vpn-instance verbose [ vpn-instance-name ] command to display the
tunnel policy applied to VPN instances.
l Run the display ip routing-table vpn-instance vpn-instance-name [ destination-
address ] verbose command to display the tunnels used by the routes of VPN instances.
l Run the display tunnel-info tunnel-id command to display information about a tunnel.
----End
Example
Run the display tunnel-policy command. If the bound tunnel interface is displayed in the output
information, it means that the configuration is successful. For example, there is a tunnel interface
in the tunnel policy, and the destination address is the same as the configured destination address.
<Quidway> display tunnel-policy policy1
Tunnel Policy Name Destination Tunnel Intf Down Switch
---------------------------------------------------------------------
policy1 2.2.2.9 Tunnel1/0/0 Disable
3.3.3.9 Tunnel2/0/0 Disable
Run the display interface tunnel command. You can see that the bound tunnel is Up. The
following is an example:
<Quidway> display interface tunnel 1/0/0
Tunnel1/0/0 current state : UP
Line protocol current state : UP
Description : HUAWEI, Quidway Series, Tunnel1/0/0 Interface, Route Port
The Maximum Transmit Unit is 1500 bytes
Internet Address is unnumbered, using address of LoopBack1(1.1.1.9/32)
Encapsulation is TUNNEL, loopback not set
Tunnel destination 2.2.2.9
Tunnel protocol/transport MPLS/MPLS, ILM is available,
primary tunnel id is 0x10002, secondary tunnel id is 0x0
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 1 VPN Tunnel Management
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-19

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals