Huawei Quidway S9300

1.7.4 Applying a Tunnel Policy to a Martini MPLS L2VPN
Context
When a PE transmits packets to the same destination over different L2VPNs, different tunnel
policies are applied and the L2VPNs are bound to different TE tunnels.
Do as follows on the PEs configured with VCs.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface vlanif vlan-id
The AC interface view is displayed.
Step 3 Run:
mpls l2vc destination vc-id tunnel-policy policy-name
A tunnel policy is applied to the VC.
----End
1.7.5 Checking the Configuration
Prerequisite
The configurations of L2VPN tunnel binding are complete.
Procedure
l Run the display tunnel-policy policy-name command to view the configurations of the
bound tunnel policy.
l Run the display interface tunnel interface-number command to view information about
the bound tunnel interface.
l Run the display mpls l2vc [ interface interface-type interface-number ] command to
display the tunnel used by the Martini L2VPN VC.
----End
Example
Run the display tunnel-policy command. If the bound tunnel interface is displayed in the output
information, it means that the configuration is successful. For example, there is a tunnel interface
in the tunnel policy, and the destination address is the same as the bound destination address.
<Quidway> display tunnel-policy policy1
Tunnel Policy Name Destination Tunnel Intf Down Switch
---------------------------------------------------------------------
policy1 2.2.2.9 Tunnel1/0/0 Disable
3.3.3.9 Tunnel2/0/0 Disable
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 1 VPN Tunnel Management
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-23