Huawei Quidway S9300

l If the Ethernet OAM function is configured on the interface that connects the PE to a CE,
and the revertive switchover policy is configured, then the value of resume-time cannot be
0. The value must be equal to or more than one second.
----End
4.9.3 Checking the Configuration
Procedure
l Run the display mpls l2vc [ vc-id | interface interface-type interface-number ] command
to view information about the local end of the Martini VC.
l Run the display mpls l2vc remote-info [ vc-id ] command to view information about the
remote end of the Martini VC.
l Run the display mpls l2vpn connection [ [ l2vpn-name [ remote-ce ce-offset | down | up
| verbose ] ] | summary | [ interface interface-type interface-number ] ] command to view
information about the Kompella VLL.
l Run the display mpls l2vpn forwarding-info [ vc-label ] interface interface-type
interface-number [ | { begin | exclude | include } regular-expression ] command to view
forwarding information about the L2VPN.
----End
Example
Run the display mpls l2vc [ vc-id | interface interface-type interface-number ] command, and
you can see that the status of the master and backup PWs is Up, the VC status of the master PW
is active, and VC status of the backup PW is Inactive. The following is an example:
<Quidway> display mpls l2vc interface vlanif 300
*client interface : Vlanif300 is up
session state : up
AC state : up
VC state : up
VC ID : 100
VC type : VLAN
destination : 3.3.3.3
local group ID : 0 remote group ID : 0
local VC label : 21504 remote VC label : 21504
local AC OAM State : up
local PSN State : up
local forwarding state : forwarding
remote AC OAM state : up
remote PSN state : up
remote forwarding state: forwarding
BFD for PW : enable
BFD sessionIndex : 257 BFD state : up
manual fault : not set
active state : active
forwarding entry : exist
link state : up
local VC MTU : 1500 remote VC MTU : 1500
local VCCV : cw bfd
remote VCCV : cw bfd
local control word : enable remote control word : enable
tunnel policy : p1
traffic behavior : --
PW template name : 1to3
primary or secondary : primary
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL type : cr lsp, TNL ID : 0x20002
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 4 VLL Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-31