Huawei Quidway S9300

create time : 0 days, 0 hours, 12 minutes, 47 seconds
up time : 0 days, 0 hours, 2 minutes, 11 seconds
last change time : 0 days, 0 hours, 2 minutes, 11 seconds
*client interface : Vlanif300 is up
session state : up
AC state : up
VC state : up
VC ID : 200
VC type : VLAN
destination : 2.2.2.2
local group ID : 0 remote group ID : 0
local VC label : 21505 remote VC label : 21504
local AC OAM state : up
local PSN state : up
local forwarding state : forwarding
remote AC OAM state : up
remote PSN state : up
remote forwarding state: forwarding
BFD for PW : enable
BFD sessionIndex : 256 BFD state : up
manual fault : not set
active state : inactive
forwarding entry : existent
link state : up
local VC MTU : 1500 remote VC MTU : 1500
local VCCV : cw bfd
remote VCCV : cw bfd
local control word : enable remote control word : enable
tunnel policy : --
traffic behavior : --
PW template name : 1to2
primary or secondary : secondary
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL type : lsp , TNL ID : 0x10004
create time : 0 days, 0 hours, 12 minutes, 47 seconds
up time : 0 days, 0 hours, 1 minutes, 32 seconds
last change time : 0 days, 0 hours, 1 minutes, 32 seconds
reroute policy : delay 30 s, resume 10 s
reason of last reroute : Remote AC fault was resumed
time of last reroute : 0 days, 0 hours, 1 minutes, 38 seconds
delay timer ID : -- rest time :--
resume timer ID : -- rest time :--
Run the display mpls l2vc remote-info command, and you can see that Peer Addr is the peer
address of the VC. The following is an example:
<Quidway> display mpls l2vc remote-info
Total remote ldp vc : 2
Transport Group Peer Remote Remote C MTU/ N S
VC ID ID Addr Encap VC Label Bit CELLS Bit Bit
100 0 3.3.3.3 vlan 21504 1 1500 1 0
200 0 2.2.2.2 vlan 21504 1 1500 1 0
Run the display mpls l2vpn connection interface command, and you can see that the local VC
status and remote VC status of the master PW and the backup PW are both Up, the forwarding
state of the master PW is true, and the forwarding state of the backup PW is false. The BFD
session is Up.
<Quidway> display mpls l2vpn connection interface Vlanif 11
conn-type: remote
local vc state: up
remote vc state: up
local ce-id: 1
local ce name: ce1
remote ce-id: 2
intf(state,encap): Vlanif11(up,vlan)
4 VLL Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
4-32 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)