Huawei Quidway S9300

For details about enabling debugging, refer to the chapter Information Center
Configuration in the Quidway S9300Terabit Routing Switch Configuration Guide - Device
Management. For the description of the debugging commands, refer to the Quidway
S9300Terabit Routing Switch Debugging Reference.
Procedure
l Run the debugging mpls lspc { all | error | event | packet } command in the user view to
enable the debugging of MPLS Ping/Tracert.
----End
5.11 Configuration Examples
This section provides several configuration examples of PWE3.
5.11.1 Example for Configuring a Dynamic SH-PW
5.11.2 Example for Configuring a Static MH-PW
5.11.3 Example for Configuring a Dynamic MH-PW
5.11.4 Example for Configuring a Mixed MH-PW
5.11.5 Example for Configuring PW FRR
5.11.6 Example for Configuring Inter-AS PWE3-Option A
5.11.1 Example for Configuring a Dynamic SH-PW
Networking Requirements
As shown in Figure 5-11, PE1 and PE2 are connected through an MPLS backbone network.
An LSP needs to be used to set a dynamic PW between PE1 and PE2.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 5 PWE3 Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-37