Procedure
l Run the reset traffic-statistics vsi all command to reset all the traffic statistics on a
specified VPLS PW.
l Run the reset traffic-statistics vsi name vsi-name [ peer peer-address [ negotiation-vc-
id vc-id ] ] command to reset the statistics of the public network traffic on a specified LDP
VPLS PW in a specified VSI.
----End
6.10.4 Debugging VPLS
Context
CAUTION
Debugging affects the performance of the system. So, after debugging, run the undo debugging
all command to disable it immediately.
When a VPLS fault occurs, run the debugging command in the user view to locate the fault.
For the procedure of enabling the debugging, refer to the chapter "Information Center" in the
Quidway S9300Terabit Routing Switch Configuration Guide - System Management. For more
information about the debugging command, refer to the Quidway S9300Terabit Routing
Switch Debugging Reference.
Procedure
l Run the debugging mpls l2vpn { advertisement | all | connections interface [ interface-
type interface-number ] | download | error | event | timer } command to enable the
debugging of MPLS L2VPN.
l Run the debugging mpls l2vpn { vpls_fib | vpls_mid } command to enable the debugging
of VPLS.
l Run: the debugging mpls packet [ error ] [ acl acl-number ] [ inlabel outer-in-label
[ inner-in-label ] ] [ l2vpn-in-interface interface-type interface-number ] command to
enable the debugging of MPLS packets.
l Run the debugging mpls ldp { advertisement | all | error | main | notification | pdu |
session | socket | timer } [ interface interface-type interface-number ] or debugging mpls
ldp { hsb | remote-peer remote-peer-name } command to enable the debugging of LDP.
----End
6.10.5 Enabling or Disabling a VSI
Context
Do as follows in the VSI view.
6 VPLS Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
6-36 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)
To Next Page
Loading...
Need help?
General
