Huawei Quidway S9300

Remote VCCV : Disable
Local Frag : Disable
Remote Frag : Disable
Local Ctrl Word : Disable
Remote Ctrl Word : Disable
Tunnel Policy : policy1
Traffic Behavior : --
PW Template Name : --
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL Type : lsp , TNL ID : 0x10002
Create time : 0 days, 0 hours, 0 minutes, 23 seconds
UP time : 0 days, 0 hours, 0 minutes, 23 seconds
Last change time : 0 days, 0 hours, 0 minutes, 23 seconds
For a Kompella L2VPN, run the display mpls l2vpn connectioninterfaceinterface-type
interface-number command. You can view the tunnel policy applied to the VC. For example,
you can find that the tunnel policy policy1 is applied to the L2VPN on VLANIF 30.
<Quidway> display mpls l2vpn connection interface vlanif 30
conn-type: remote
local vc state: up,
remote vc state: up,
local ce-id: 1,
local ce name: ce1,
remote ce-id: 2,
intf(state,encap): Vlanif30(up,VLAN),
peer id: 3.3.3.9,
route-distinguisher: 100:1,
local vc label: 19456,
remote vc label: 19456,
tunnel policy: policy1
tunnel type: lsp , id: 0x10018
1.6 Binding the Primary Tunnel for L3VPN
This section describes how to configure a dedicated tunnel for the L3VPN.
1.6.1 Establishing the Configuration Task
1.6.2 Enabling the VPN Binding Feature for the Tunnel
1.6.3 Binding the Tunnel Policy to a VPN
1.6.4 Applying the Tunnel Policy on L3VPN
1.6.5 Checking the Configuration
1.6.1 Establishing the Configuration Task
Applicable Environment
When deploying VPN services, you can bind an MPLS TE tunnel to the VPN to transmit VPN
services. Thus, the VPN service can occupy the tunnel exclusively. Through the configuration,
the congestion caused by unbalanced load can be avoided, and the QoS of the VPN service can
be guaranteed.
Pre-configuration Tasks
Before configuring VPN tunnel binding, complete the following tasks:
1 VPN Tunnel Management
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
1-16 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)