Huawei Quidway S9300

4.5.4 Checking the Configuration
Prerequisite
The configurations of the Martini VLL are complete.
Procedure
l Run the display mpls l2vc [ vc-id | interfaceinterface-type interface-number ] command
on the PE to view information about the Martini VLL on the local PE.
l Run the display mpls l2vc remote-info [ vc-id ] command on the PE to view information
about the Martini VLL on the remote PE.
l Run the display mpls l2vc brief command to view brief information about the Martini
VLL.
----End
Example
Run the display mpls l2vc command, and you can see that the destination address is the peer
IP address of the VC and the VC is in Up state. The following is an example:
<Quidway> display mpls l2vc
total LDP VC : 1 1 up 0 down
*client interface : Vlanif300
session state : up
AC status : up
VC state : up
VC ID : 101
VC type : VLAN
destination : 2.2.2.9
local VC label : 21504 remote VC label : 21504
control word : disable
forwarding entry : exist
local group ID : 0
manual fault : not set
active state : active
link state : up
local VC MTU : 1500 remote VC MTU : 1500
tunnel policy name : --
traffic behavior name: --
PW template name : --
primary or secondary : primary
create time : 0 days, 0 hours, 5 minutes, 50 seconds
up time : 0 days, 0 hours, 5 minutes, 0 seconds
last change time : 0 days, 0 hours, 5 minutes, 50 seconds
Run the display mpls l2vc remote-info command, and you can see that "Peer Addr" is the
peer address of the VC. The following is an example:
<Quidway> display mpls l2vc remote-info
Total remote ldp vc : 1
Transport Group Peer Remote Remote C MTU/ N S
VC ID ID Addr Encap VC Label Bit CELLS Bit Bit
101 0 2.2.2.9 vlan 21504 0 1500 0 0
4 VLL Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
4-16 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)