Huawei Quidway S9300

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip vpn-instance vpn-instance-name
The VPN instance view is displayed.
Step 3 Run:
vpn frr route-policy route-policy-name
VPN FRR is enabled.
----End
3.10.4 Checking the Configuration
Prerequisite
The configurations of the VPN FRR are complete.
Procedure
l Run the display ip routing-table vpn-instance vpn-instance-name [ filter-option ]
verbose command to view the backup next hop (PE address), backup tunnel, and backup
label in the routing table.
----End
Example
Run the display ip routing-table vpn-instance verbose command on the PE enabled with VPN
FRR, and you can see the backup next hop (PE address), backup tunnel, and backup label of the
route. For example, configure the primary next hop and the backup next hop of route 10.1.1.0
to 2.2.2.2 and 3.3.3.3 respectively. The information about the backup next hop, backup tunnel,
and backup label is as follows:
<Quidway> display ip routing-table vpn-instance vpn1 10.1.1.0 verbose
Routing Table : vpn1
Summary Count : 2
Destination: 10.1.1.0/30
Protocol: BGP Process ID: 0
Preference: 255 Cost: 0
NextHop: 3.3.3.3 Neighbour: 3.3.3.3
State: Inactive Adv GotQ Age: 01h02m04s
Tag: 0 Priority: 0
Label: 15363 QoSInfo: 0x0
RelayNextHop: 0.0.0.0 Interface: Vlanif20
TunnelID: 0x10001
Destination: 10.1.1.0/30
Protocol: BGP Process ID: 0
Preference: 255 Cost: 0
NextHop: 2.2.2.2 Neighbour: 2.2.2.2
State: Active Adv GotQ Age: 00h21m57s
3 BGP/MPLS IP VPN Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3-42 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)