Huawei Quidway S9300

[PE1-vpn-instance-vpnb] vpn-target 200:200 import-extcommunity
[PE1-vpn-instance-vpnb] quit
[PE1] interface vlanif 100
[PE1-Vlanif100] ip binding vpn-instance vpna
[PE1-Vlanif100] ip address 14.1.1.1 255.255.255.0
[PE1-Vlanif100] quit
[PE1] interface vlanif 101
[PE1-Vlanif101] ip binding vpn-instance vpnb
[PE1-Vlanif101] ip address 14.1.1.1 255.255.255.0
[PE1-Vlanif101] quit
# Configure PE2.
[PE2] ip vpn-instance vpna
[PE2-vpn-instance-vpna] route-distinguisher 200:200
[PE2-vpn-instance-vpna] vpn-target 100:100 export-extcommunity
[PE2-vpn-instance-vpna] vpn-target 100:100 import-extcommunity
[PE2-vpn-instance-vpna] quit
[PE2] ip vpn-instance vpnb
[PE2-vpn-instance-vpnb] route-distinguisher 400:400
[PE2-vpn-instance-vpnb] vpn-target 200:200 export-extcommunity
[PE2-vpn-instance-vpnb] vpn-target 200:200 import-extcommunity
[PE2-vpn-instance-vpnb] quit
[PE2] interface vlanif 100
[PE2-Vlanif100] ip binding vpn-instance vpna
[PE2-Vlanif100] ip address 34.1.1.1 255.255.255.0
[PE2-Vlanif100] quit
[PE2] interface vlanif 101
[PE2-Vlanif101] ip binding vpn-instance vpnb
[PE2-Vlanif101] ip address 34.1.1.1 255.255.255.0
[PE2-Vlanif101] quit
# Assign IP addresses to the interfaces on the CEs according to Figure 3-4. The configuration
procedure is not mentioned here.
After the configuration, run the display ip vpn-instance verbose command on the PEs, and you
can see the configuration of the VPN instances. The PEs can ping the connected CEs
successfully.
Take the display on PE1 and CE1 as an example.
[PE1] display ip vpn-instance verbose
Total VPN-Instances configured : 2
VPN-Instance Name and ID : vpna, 1
Create date : 2008/11/24 16:28:27
Up time : 0 days, 00 hours, 11 minutes and 25 seconds
Route Distinguisher : 100:100
Export VPN Targets : 100:100
Import VPN Targets : 100:100
Label policy : label per route
The diffserv-mode Information is : uniform
The ttl-mode Information is : pipe
Interfaces : Vlanif100
VPN-Instance Name and ID : vpnb, 2
Create date : 2008/11/24 16:30:37
Up time : 0 days, 00 hours, 09 minutes and 15 seconds
Route Distinguisher : 300:300
Export VPN Targets : 200:200
Import VPN Targets : 200:200
Label policy : label per route
The diffserv-mode Information is : uniform
The ttl-mode Information is : pipe
Interfaces : Vlanif101
[PE1] ping -vpn-instance vpna 14.1.1.2
PING 14.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 14.1.1.2: bytes=56 Sequence=1 ttl=255 time=5 ms
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 3 BGP/MPLS IP VPN Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-73