Huawei Quidway S9300

Take the display on PE1 as an example.
[PE1] display ip routing-table vpn-instance vpna
Route Flags: R - relay, D - download to fib
------------------------------------------------------------------------------
Routing Tables: vpna
Destinations : 5 Routes : 5
Destination/Mask Proto Pre Cost Flags NextHop Interface
14.1.1.0/24 Direct 0 0 D 14.1.1.1 Vlanif100
14.1.1.1/32 Direct 0 0 D 127.0.0.1 InLoopBack0
14.1.1.255/32 Direct 0 0 D 127.0.0.1 InLoopBack0
34.1.1.0/24 BGP 255 0 RD 3.3.3.9 Vlanif10
255.255.255.255/32 Direct 0 0 D 127.0.0.1 InLoopBack0
[PE1] display ip routing-table vpn-instance vpnb
Route Flags: R - relay, D - download to fib
------------------------------------------------------------------------------
Routing Tables: vpnb
Destinations : 5 Routes : 5
Destination/Mask Proto Pre Cost Flags NextHop Interface
14.1.1.0/24 Direct 0 0 D 14.1.1.1 Vlanif101
14.1.1.1/32 Direct 0 0 D 127.0.0.1 InLoopBack0
14.1.1.255/32 Direct 0 0 D 127.0.0.1 InLoopBack0
34.1.1.0/24 BGP 255 0 RD 3.3.3.9 Vlanif10
255.255.255.255/32 Direct 0 0 D 127.0.0.1 InLoopBack0
Run the ping 34.1.1.1 command on CE1, and the ping is successful. Run the display
interface command to view the statistics about packets on GE 3/0/1 and GE3/0/2 of PE2, and
you can see that there are packets passing through GE 3/0/1 but there is not any packet passing
through GE3/0/2. This indicates that the two VPN instances contain same addresses but users
in the VPNs cannot communicate with each other.
<PE2> display interface GigabitEthernet 3/0/1
GigabitEthernet3/0/1 current state : UP
Description:HUAWEI, Quidway Series, GigabitEthernet3/0/1 Interface
Switch Port,PVID : 100,The Maximum Frame Length is 1526
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0018-2000-0116
Speed : 1000, Loopback: NONE
Duplex: FULL, Negotiation: ENABLE
Mdi : NORMAL
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 256 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes
Unicast: 0, NUnicast: 0
Discard: 0, Error : 0
Jumbo : 0
Output : 58 packets, 207872 bytes
Unicast: 58, NUnicast: 0
Discard: 0, Error : 0
Jumbo : 0
<PE2> display interface GigabitEthernet 3/0/2
GigabitEthernet3/0/2 current state : UP
Description:HUAWEI, Quidway Series, GigabitEthernet3/0/2 Interface
Switch Port,PVID : 101,The Maximum Frame Length is 1526
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0018-2000-0116
Speed : 1000, Loopback: NONE
Duplex: FULL, Negotiation: ENABLE
Mdi : NORMAL
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 256 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes
Unicast: 0, NUnicast: 0
Discard: 0, Error : 0
Jumbo : 0
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 3 BGP/MPLS IP VPN Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-75