Huawei Quidway S9300

------------------------------------------------------------------------------
Routing Tables: Public
Destinations : 9 Routes : 9
Destination/Mask Proto Pre Cost Flags NextHop Interface
1.1.1.9/32 Direct 0 0 D 127.0.0.1 InLoopBack0
2.2.2.9/32 OSPF 10 2 D 168.1.1.2 Vlanif20
3.3.3.9/32 OSPF 10 3 D 168.1.1.2 Vlanif20
127.0.0.0/8 Direct 0 0 D 127.0.0.1 InLoopBack0
127.0.0.1/32 Direct 0 0 D 127.0.0.1 InLoopBack0
168.1.1.0/24 Direct 0 0 D 168.1.1.1 Vlanif20
168.1.1.1/32 Direct 0 0 D 127.0.0.1 InLoopBack0
168.1.1.2/32 Direct 0 0 D 168.1.1.2 Vlanif20
169.1.1.0/24 OSPF 10 2 D 168.1.1.2 Vlanif20
Run the display ospf peer command, and you can see that the OSPF neighbor relation is set up
and the neighbor status is Full.
Take the display on PE1 for example:
<PE1> display ospf peer
OSPF Process 1 with Router ID 1.1.1.9
Neighbors
Area 0.0.0.0 interface 168.1.1.1(Vlanif20)'s neighbors
Router ID: 2.2.2.9 Address: 168.1.1.2
State: Full Mode:Nbr is Master Priority: 1
DR: None BDR: None MTU: 0
Dead timer due in 35 sec
Neighbor is up for 00:17:12
Authentication Sequence: [ 0 ]
Step 3 Configure basic MPLS functions and LDP, and set up LDP LSPs.
The configuration procedure is not mentioned here.
After the configuration, run the display mpls ldp session and display mpls ldp peer commands
on each LSR. You can see information about the LDP session and peers.
Take the display on PE1 for example:
<PE1> display mpls ldp session
LDP Session(s) in Public Network
------------------------------------------------------------------------------
Peer-ID Status LAM SsnRole SsnAge KA-Sent/Rcv
------------------------------------------------------------------------------
2.2.2.9:0 Operational DU Passive 000:00:01 5/5
------------------------------------------------------------------------------
TOTAL: 1 session(s) Found.
LAM : Label Advertisement Mode SsnAge Unit : DDD:HH:MM
<PE1> display mpls ldp peer
LDP Peer Information in Public network
------------------------------------------------------------------------------
Peer-ID Transport-Address Discovery-Source
------------------------------------------------------------------------------
2.2.2.9:0 2.2.2.9 Vlanif20
------------------------------------------------------------------------------
TOTAL: 1 Peer(s) Found.
Run the display mpls lsp command, and you can see the status of the LSP.
Take the display on PE1 for example:
4 VLL Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
4-64 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)