Huawei Quidway S9300

[PE2-mpls-l2vpn-ce-vpn1-ce2] quit
[PE2-mpls-l2vpn-vpn1] quit
Step 6 Verify the configuration.
After the configuration, run the display mpls l2vpn connection command on PEs, and you can
see that an L2VPN connection is in Up state.
Take the display on PE1 for example.
<PE1> display mpls l2vpn connection
1 total connections,
connections: 1 up, 0 down, 0 local, 1 remote, 0 unknown
VPN name: vpn1,
1 total connections,
connections: 1 up, 0 down, 0 local, 1 remote, 0 unknown
CE name: ce1, id: 1,
Rid type status peer-id route-distinguisher interface
primary or not
----------------------------------------------------------------------------
1 rmt up 3.3.3.9 100:1 Vlanif10
primary
CE1 and CE2 can ping each other.
<CE1> ping 30.1.1.2
PING 30.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 30.1.1.2: bytes=56 Sequence=1 ttl=255 time=90 ms
Reply from 30.1.1.2: bytes=56 Sequence=2 ttl=255 time=77 ms
Reply from 30.1.1.2: bytes=56 Sequence=3 ttl=255 time=34 ms
Reply from 30.1.1.2: bytes=56 Sequence=4 ttl=255 time=46 ms
Reply from 30.1.1.2: bytes=56 Sequence=5 ttl=255 time=94 ms
--- 30.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 34/68/94 ms
----End
Configuration Files
l Configuration file of CE1
#
sysname CE1
#
vlan batch 10
#
interface Vlanif10
ip address 30.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 10
#
return
l Configuration file of PE1
#
sysname PE1
#
vlan batch 10 20
#
mpls lsr-id 1.1.1.9
mpls
#
4 VLL Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
4-66 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)