Huawei Quidway S9300

[ASBR-PE1] mpls l2vpn
[ASBR-PE1-l2vpn] mpls l2vpn default martini
[ASBR-PE1-l2vpn] quit
[ASBR-PE1] interface vlanif 30
[ASBR-PE1-Vlanif30] mpls l2vc 1.1.1.9 100
[ASBR-PE1-Vlanif30] quit
# Configure ASBR-PE2.
[ASBR-PE2] mpls l2vpn
[ASBR-PE2-l2vpn] mpls l2vpn default martini
[ASBR-PE2-l2vpn] quit
[ASBR-PE2] interface vlanif 30
[ASBR-PE2-Vlanif30] mpls l2vc 4.4.4.9 100
[ASBR-PE2-Vlanif30] quit
# Configure PE2.
[PE2] mpls l2vpn
[PE2-l2vpn] mpls l2vpn default martini
[PE2-l2vpn] quit
[PE2] interface vlanif 50
[PE2-Vlanif50] mpls l2vc 3.3.3.9 100
[PE2-Vlanif50] quit
# Configure CE1.
[CE1] interface vlanif 10
[CE1-Vlanif10] ip address 100.1.1.1 255.255.255.0
[CE1-Vlanif10] quit
# Configure CE2.
[CE2] interface vlanif 50
[CE2-Vlanif50] ip address 100.1.1.2 255.255.255.0
[CE2-Vlanif50] quit
Step 5 Verify the configuration.
Display information about the L2VPN connection on PE1. You can see that an L2VC is set up
and the VC status is Up.
Take the display on PE1 for example.
<PE1> display mpls l2vc interface Vlanif 10
*client interface : Vlanif10 is up
session state : up
AC state : up
VC state : up
VC ID : 100
VC type : VLAN
destination : 2.2.2.9
local group ID : 0 remote group ID : 0
local VC label : 21505 remote VC label : 21505
local AC OAM State : up
local PSN State : up
local forwarding state : forwarding
remote AC OAM state : up
remote PSN state : up
remote forwarding state: forwarding
BFD for PW : disable
manual fault : not set
active state : active
forwarding entry : exist
link state : up
local VC MTU : 1500 remote VC MTU : 1500
local VCCV : Disable
remote VCCV : Disable
local control word : disable remote control word : disable
4 VLL Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
4-72 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)