Huawei Quidway S9300

AC OAM state: up
BFD for PW session index: --
BFD for PW state: invalid
BFD for LSP state: true
Local C bit is set, Remote C bit is set
tunnel type: cr lsp, id: 0x1003d
conn-type: remote
local vc state: up
remote vc state: up
local ce-id: 1
local ce name: ce1
remote ce-id: 3
intf(state,encap): Vlanif10(up,vlan)
peer id: 2.2.2.2
route-distinguisher: 100:3
local vc label: 25603
remote vc label: 25601
tunnel policy: default
primary or secondary: secondary
forwardEntry exist or not: true
forward entry active or not:false
manual fault set or not: not set
AC OAM state: up
BFD for PW session index: --
BFD for PW state: invalid
BFD for LSP state: true
Local C bit is set, Remote C bit is set
tunnel type: lsp , id: 0x10028
Reroute policy : delay 30 s, resume 0 s
Reason of last reroute : --
Time of last reroute : 0 days, 0 hours, 48 minutes, 52 seconds
delay timer ID : -- rest time :--
resume timer ID : -- rest time :--
Check the routing table on CE2, and you can see that the outgoing interface of the routes destined
for 10.1.3.0 changes to VLANIF 60. That is, the L2VPN traffic is switched back to the primary
path.
<CE2> display ip routing-table
Route Flags: R - relied, D - download to fib
------------------------------------------------------------------------------
Routing Tables: Public
Destinations : 5 Routes : 5
Destination/Mask Proto Pre Cost Flags NextHop Interface
10.1.1.0/30 Direct 0 0 D 10.1.1.2 Vlanif60
10.1.1.2/32 Direct 0 0 D 127.0.0.1 InLoopBack0
10.1.3.1/32 OSPF 10 2 D 10.1.1.1 Vlanif60
127.0.0.0/8 Direct 0 0 D 127.0.0.1 InLoopBack0
127.0.0.1/32 Direct 0 0 D 127.0.0.1 InLoopBack0
----End
Configuration Files
l Configuration file of CE1
#
sysname CE1
#
vlan batch 10 70
#
interface Vlanif10
ip address 10.1.1.1 255.255.255.0
ip address 10.1.2.1 255.255.255.0 sub
#
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 4 VLL Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-115