Huawei Quidway S9300

Client1 can ping 10.1.1.2 on Client2.
[Client1] ping 10.1.1.2
PING 10.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 10.1.1.2: bytes=56 Sequence=1 ttl=254 time=210 ms
Reply from 10.1.1.2: bytes=56 Sequence=2 ttl=254 time=190 ms
Reply from 10.1.1.2: bytes=56 Sequence=3 ttl=254 time=160 ms
Reply from 10.1.1.2: bytes=56 Sequence=4 ttl=254 time=130 ms
Reply from 10.1.1.2: bytes=56 Sequence=5 ttl=254 time=190 ms
--- 10.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 130/176/210 ms
Run the display mac-address dynamic command on CEs. Take the display on CE2 for example.
You can see that GE1/0/0 has learned the MAC address of Client1 (00e0-413f-8401) and
GE1/0/2 has learned the MAC address of Client2 (00e0-c279-e10a 10). This indicates that the
clients use the master link CE2 → PE3 → P → PE1 to forward data again.
[CE2] display mac-address dynamic 1
MAC Address VLAN/VSI PEVLAN CEVLAN Port Type Lsp
--------------------------------------------------------------------------------
00e0-413f-8401 10 - - GE1/0/0 dynamic 1/0
00e0-c279-e10a 10 - - GE1/0/2 dynamic 1/0
Total 2 ,2 printed
----End
Configuration Files
l Configuration file of CE1
#
sysname CE1
#
vlan batch 10 70
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 10
#
interface GigabitEthernet1/0/1
port link-type trunk
port trunk allow-pass vlan 70
#
return
l Configuration file of CE2
#
sysname CE2
#
vlan batch 50 60 80
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 60
#
interface GigabitEthernet1/0/1
port link-type trunk
port trunk allow-pass vlan 50
#
interface GigabitEthernet1/0/2
port link-type trunk
port trunk allow-pass vlan 80
5 PWE3 Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
5-88 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)