Huawei Quidway S9300

remote PSN state : up
remote forwarding state: forwarding
BFD for PW : unavailable
manual fault : not set
active state : active
forwarding entry : exist
link state : up
local VC MTU : 1500 remote VC MTU : 1500
local VCCV : Disable
remote VCCV : Disable
local control word : disable remote control word : disable
tunnel policy : --
traffic behavior : --
PW template name : --
primary or secondary : primary
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL type : lsp , TNL ID : 0x20021
create time : 0 days, 0 hours, 8 minutes, 8 seconds
up time : 0 days, 0 hours, 7 minutes, 26 seconds
last change time : 0 days, 0 hours, 7 minutes, 26 seconds
<ASBR-PE2> display mpls l2vc interface vlanif 30
*client interface : Vlanif30 is up
session state : up
AC state : up
VC state : up
VC ID : 100
VC type : VLAN
destination : 4.4.4.9
local group ID : 0 remote group ID : 0
local VC label : 21505 remote VC label : 21505
local AC OAM State : up
local PSN State : up
local forwarding state : forwarding
remote AC OAM state : up
remote PSN state : up
remote forwarding state: forwarding
BFD for PW : unavailable
manual fault : not set
active state : active
forwarding entry : exist
link state : up
local VC MTU : 4470 remote VC MTU : 4470
local VCCV : Disable
remote VCCV : Disable
local control word : disable remote control word : disable
tunnel policy : --
traffic behavior : --
PW template name : --
primary or secondary : primary
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL type : lsp , TNL ID : 0x20021
create time : 0 days, 0 hours, 8 minutes, 7 seconds
up time : 0 days, 0 hours, 7 minutes, 26 seconds
last change time : 0 days, 0 hours, 7 minutes, 26 seconds
CE1 and CE2 can ping each other.
Take the display on CE1 for example.
<CE1> ping 100.1.1.2
PING 100.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=430 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=220 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=190 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=190 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=190 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 PWE3 Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
5-96 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)