After the configuration, run the display mpls ldp session on PE1 or PE2. You can find that the
status of the peer relationship between PE1 and PE2 is Operational, which indicates that the
peer relationship is established.
Step 5 Enable MPLS L2VPN on PEs.
# Configure PE1.
[PE1] mpls l2vpn
# Configure PE2.
[PE2] mpls l2vpn
Step 6 Configure VSIs on PEs.
# Configure PE1.
[PE1] vsi a2 static
[PE1-vsi-a2] pwsignal ldp
[PE1-vsi-a2-ldp] vsi-id 2
[PE1-vsi-a2-ldp] peer 3.3.3.9
# Configure PE2.
[PE2] vsi a2 static
[PE2-vsi-a2] pwsignal ldp
[PE2-vsi-a2-ldp] vsi-id 2
[PE2-vsi-a2-ldp] peer 1.1.1.9
Step 7 Bind VSIs to interfaces on PEs.
# Configure PE1.
[PE1] interface vlanif 10
[PE1-Vlanif10] l2 binding vsi a2
[PE1-Vlanif10] quit
# Configure PE2.
[PE2] interface vlanif 40
[PE2-Vlanif40] l2 binding vsi a2
[PE2-Vlanif40] quit
Step 8 Assign an IP address to each VLANIF interface on CEs.
# Configure CE1.
<Quidway> sysname CE1
[CE1] interface vlanif 10
[CE1-Vlanif10] ip address 10.1.1.1 255.255.255.0
[CE1-Vlanif10] quit
# Configure CE2.
<Quidway> sysname CE2
[CE2] interface vlanif 40
[CE2-Vlanif40] ip address 10.1.1.2 255.255.255.0
[CE2-Vlanif40] quit
Step 9 Verify the configuration.
After the preceding configurations, run the display vsi name a2 verbose command on PE1. You
can find that a VSI named a2 sets up a PW to PE2, and the status of the VSI is UP.
.
<PE1> display vsi name a2 verbose
6 VPLS Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
6-40 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)
To Next Page
Loading...
Need help?
General
