EasyManuals Logo

Huawei Quidway S9300 Configuration Guide

Huawei Quidway S9300
567 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
Configuration Roadmap
The configuration roadmap is as follows:
1. Run IGP on the S9300s on the backbone network (OSPF process 1 is used here).
2. Create GRE tunnels between the S9300s connected with PCs so that data between any two
PCs is transmitted through GRE tunnels.
3. Run the dynamic routing protocol on the network segment where the PCs access the
backbone network (OSPF process 2 is used here).
Data Preparation
To complete the configuration, you need the following data:
l IDs of the VLANs that the interfaces belong to, as shown in Figure 2-6
l IP address of the VLANIF interfaces , as shown in Figure 2-6
l Source addresses and destination addresses on the two ends of the GRE tunnel
l IP addresses of the interfaces on the two ends of the GRE tunnel
Procedure
Step 1 Assign the IP address to each interface.
<Quidway> system-view
[Quidway] sysname S9300-A
[S9300-A] vlan batch 10 30
[S9300-A] interface gigabitEthernet 1/0/0
[S9300-A-GigabitEthernet1/0/0] port hybrid pvid vlan 10
[S9300-A-GigabitEthernet1/0/0] port hybrid untagged vlan 10
[S9300-A-GigabitEthernet1/0/0] quit
[S9300-A] interface gigabitEthernet 2/0/0
[S9300-A-GigabitEthernet2/0/0] port hybrid pvid vlan 30
[S9300-A-GigabitEthernet2/0/0] port hybrid untagged vlan 30
[S9300-A-vlan30] quit
[S9300-A] interface vlanif 10
[S9300-A-Vlanif10] ip address 20.1.1.1 24
[S9300-A-Vlanif10] quit
[S9300-A] interface vlanif 30
[S9300-A-Vlanif30] ip address 10.1.1.2 24
[S9300-A-Vlanif30] quit
The configurations of S9300-B and S9300-C are similar to the configuration of S9300-A, and
are not mentioned here.
Step 2 Configure IGP on the VPN backbone network.
The configuration procedure is the same as that in Example for Configuring Static Routes on
the GRE Tunnel.
Step 3 Configure the tunnel interface.
The configuration procedure is the same as that in Example for Configuring Static Routes on
the GRE Tunnel.
Step 4 Configure the OSPF protocol on the tunnel interfaces.
# Configure S9300-A.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 2 GRE Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2-21

Table of Contents

Other manuals for Huawei Quidway S9300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S9300 and is the answer not in the manual?

Huawei Quidway S9300 Specifications

General IconGeneral
BrandHuawei
ModelQuidway S9300
CategoryNetwork Router
LanguageEnglish

Related product manuals