KAESER ESD.2C - Interpreting System Messages

17 Interpreting system messages
System messages are identified with the letter Y.
The message numbers are not numbered consecutively.
Message Possible
cause
Remedy
0001 Y
Hardware watchdog reset
System error Contact an authorized KAESER service
representative.
0002 Y
Internal software error
System error Contact an authorized KAESER service
representative.
0003 Y
Filesystem Read/Write failure
System error Contact an authorized KAESER service
representative.
0004 Y
CPU load too high
System error Contact an authorized KAESER service
representative.
0005 Y
RAM out of memory
System error Contact an authorized KAESER service
representative.
1000 Y
RFID error: switch SIGMA
CONTROL power supply OFF → ON!
System error Contact an authorized KAESER service
representative.
Tab. 7 System messages and remedies
17 Interpreting system messages
36
Quick user guide Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3 9_9450 03 USE