8.4.1 Selecting the Status menu
1. In operating mode, switch to the main menu with the «Enter» key.
2. Select the
< Status ➙ Messages >
menu.
The
<messages>
menu is displayed.
The number of current faults and warnings is displayed in the two bottom lines.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
1.1 Messages
Menu
▶1 Current messages
Active line
▶2 Message history
Status report 01:00 ☐
------------------------------
current Alarms 2
Number of currently registered faults
Warnings2
Number of currently registered warnings
Displaying the last fault/warning
1. In operating mode, switch to the main menu with the «Enter» key.
2. Select the
< Status ➙ Messages ➙ Current messages >
menu.
The third line displays the last fault or warning message.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
1.1.1 Current messages
Menu
0021 S q 16.04.13 13:32:49
Active line
Refrigeration dryer T ⇟
0015 W q 21.01.11 13:06:43
Bus alarm
0911 D q 21.01.11 13:07:47
AIR1.3 — Sensor fault
3. Press «Esc» repeatedly to return to the Main Menu.
Displaying the message history
1. In operating mode, switch to the main menu with the «Enter» key.
2. Select the
< Status ➙ Messages ➙ Message history >
menu.
The
<message history>
menu is displayed.
The messages in the three submenus are displayed in the order of their occurrence.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
1.1.2 Message history
Menu
▶1 Compressor messages
Active line with Compressor messages submenu
▶2 Diagnostic messages
Diagnostic messages
▶3 System messages
System messages
8 Operation
8.4 Displaying messages
144
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3 9_9450 03USE
To Next Page