KAESER ESD.2C - Activating;Deactivating the LOAD;IDLE Key

2. Press «DOWN» repeatedly until the following is displayed:
8 9 p s i 0 8 : 1 5 1 7 6 ° F
5.2.2 Pressure settings
Menu
Pressure rise
pE SP : 122 psi ¦ SD : - 7 psi
Pressure increase
ΔpFC : 3 psi
Active line with pressure rise dpFC
·········
Nominal pressure 116 psi
·········
3. Press «Enter» to switch into setting mode.
4. Use «UP» or «DOWN» to adjust the setting.
5. Press «Enter» to accept the setting.
6. Press «Esc» repeatedly to return to the Main Menu.
7.4.3 Activating/deactivating the «LOAD/IDLE» key
In order to prevent unauthorized users from switching the machine to IDLE, you can deactivate the
«LOAD/IDLE» key on the operating panel.
Precondition Password level 2 is activated,
The < Configuration ➙ Pressure control ➙ Load control > menu is selected (see Section 7.2.1).
1. Press «UP» or «DOWN» repeatedly until < Key idle > is displayed as the active line.
2. Press «Enter» to switch into setting mode.
The check box < Key idle > will flash.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
5.2.3 Load control
Menu
pA/pB DO DOR1.04 ☐
·········
Load RC DI1.13 ok ☑
loc.-load RC DI1.09 ☑
·········
Key idle : ☑
Active line with check box
3. Press «UP».
The deactivated check box is displayed.
7 Initial Start-up
7.4 Adjusting the pressure parameters of the machine
64
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3 9_9450 03USE