KAESER ESD.2C - Activating the Remote Control Key; Selecting the < Configuration ➙ Acknowledgement > Menu; Setting the Remote Acknowledgement Function

7.12.1 Selecting the < Configuration ➙ Acknowledgement > menu
Precondition Access level 2 is activated.
1. In operating mode, switch to the main menu with the «Enter» key.
2. Select the < Configuration ➙ Acknowledgement > menu.
Remote mode line is displayed as the active line.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
5.5 Acknowledgement
Menu
Remote mode : Key
Active line with "Key" setting
Key remote : ☐
The Remote control key is deactivated.
·········
RC ack DI 1.11 ☐
7.12.2 Setting the remote acknowledgement function
1. Press «Enter» to switch into setting mode.
Key flashes.
2. Press «UP».
The Key+RC menu is displayed.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
5.5 Acknowledgement
Menu
Remote mode : Key+RC
Active line with "Key + Remote contact" setting
Key remote : ☐
·········
RC ack DI 1.11 ☐
3. Press «Enter» to accept the setting.
Result The Remote acknowledgement function is set.
7.12.3 Activating the «Remote control» key
1. Press «DOWN» once.
Key remote line is displayed as the active line.
2. Press «Enter» to switch into setting mode.
The check box for Key remote will flash.
7 Initial Start-up
7.12 Activating remote acknowledgement
134
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3 9_9450 03USE