KAESER ESD.2C - Access Rights; Activating Keys with Check Boxes; Resetting Current Parameters

Resetting current parameters
In order to reset current parameters to Zero, activate the check box for Reset in the active line of
the display.
First, press «Enter» to switch into setting mode. The check box Reset will flash.
You then press «UP». The check box is activated and flashes.
Press «Enter» to save the settings.
The parameters no longer flash and are reset. The check box for Reset is again deactivated.
Check box Reset Status
☒ activated
☐ deactivated
Tab. 26 Reset check box status
4.3.4 Activating keys with check boxes
Certain keys of the SIGMA CONTROL 2 are locked by default. Activate the corresponding check
boxes in the active line of the display to unlock these keys.
First, press «Enter» to switch into setting mode. The check box will flash.
You then press «Up». The check box is activated and flashes.
Press again «Enter» to save the settings.
The display line no longer flashes and the key is activated.
Proceed correspondingly to deactivate a key.
Check box Status
☑ activated
☐ deactivated
Tab. 27 Check box status
4.4 Access rights
Access to the controller is governed by the user name combined with a password.
Users log on using an RFID Equipment Card by default. Alternatively, you can manually enter the
user name and the password.
Throughout this operating manual, the RFID Equipment Card will be simply called the "Equip‐
ment Card".
When the controller is switched on, the lowest level of access (level 0) is activated.
You have access to a further level: Level 2.
In level 2, you can display and specify further parameters and, for instance, reset the system pres‐
sure or the maintenance counters.
The access level will automatically return to level 0 after 10 minutes without any key being pressed.
4 Design and Function
4.4 Access rights
16
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3 9_9450 03USE