7 Initial Start-up
7.1 Outline
SIGMA CONTROL 2 was designed and developed for a number of applications. Potential settings
are correspondingly varied.
It is possible that only a few of these settings are needed for the initial start-up. This depends on
the application.
The following sections explain the large number of practical applications, but only one configuration
is relevant for any specific use.
7.2: Configuring the controller (display format, units, languages, etc.)
7.3: Using KAESER CONNECT
7.4: Adjusting the pressure parameters of the machine and possible modules
7.5: Configuring machine start and stop
7.6: Activating and adjusting the control modes
7.8: Configuring the machine for local mode
7.9: Configuring the machine for master control
7.10: Configuring email
7.11: Configuring input and output signals
7.12: Activating remote acknowledgement
7.13: Linking to an external pressure transducer
7.14: Commissioning the machine
7.2 Configuring the controller
All controller settings are explained in detail in the following sections. The most common set‐
tings are summarized for experienced users in the section titled "Important settings" in the
front of this manual.
➤ Carry out settings as required:
■ 7.2.1: Selecting menu options (introduction)
■ 7.2.2: Changing the display language
■ 7.2.3: Note the number of the KAESER Equipment Card
■ 7.2.4: Control access to SIGMA CONTROL 2 with the Equipment Card
■ 7.2.5: Generate password for SIGMA CONTROL 2
■ 7.2.6: Control access to SIGMA CONTROL 2 via manual input
■ 7.2.7: Generate password for KAESER CONNECT
■ 7.2.8: Set time and date
■ 7.2.9: Set display formats (date, time, units of pressure, and temperature)
■ 7.2.10: Activate summer/winter time
■ 7.3.6: Add user accounts
7.2.1 Selecting menu options
All menu options can be selected with the «DOWN», «UP» and «Enter» keys.
7 Initial Start-up
7.1 Outline
36
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3 9_9450 03USE
To Next Page
Loading...
