8. Press «Enter» to accept the setting.
ok
is displayed.
The output is assigned and activated.
7.11.3.7 Selecting the message type (operational, alarm, warning)
1. Press «DOWN» once until message type is displayed as the active line.
2. Press «Enter» to switch into setting mode.
The display of
Message type
flashes.
3. Use «UP» to select the corresponding message type.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
5.7.3.1 External message 1
Menu
External message 1
Message name
DI 1.11 ok ☑
td : 1 s ¦ Logic +
Logic
DOR 1.04 ok ☑
Alarm ☑
Example: Fault message type
4. Press «Enter» to accept the setting.
Result The input signal is available as external message 1 and/or as output.
7.12 Activating remote acknowledgement
When warning or fault messages are routed to a remote control center via an output it makes
sense to have these messages acknowledged by the control center.
Acknowledging the message without correcting the cause, however, can lead to machine damage.
Safety-relevant messages such as "Emergency-Off" cannot be acknowledged with this function.
The following conditions must be fulfilled:
■ The "Remote acknowledgement" function and the «Remote control» key are activated.
■ A controller input has been assigned for the acknowledgement signal.
Overview
■ Enter access level 2.
■ Select the
< Configuration ➙ Acknowledgement >
menu.
■ Set the "Remote acknowledgement" function.
■ Activate the «Remote control» key
■ Assigning an input
■ Press the «Remote control» key.
Machine damage can result from acknowledging a fault message without remedying its
cause!
➤ Find the fault and then decide to acknowledge or not.
7 Initial Start-up
7.12 Activating remote acknowledgement
9_9450 03USE
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3
133
To Next Page
Loading...
