Fig. 15 Status menu with submenus
1 Messages
2 Statistics
3 Current pressure regulation
4 Current operating mode
5 DI/DO display
6 pN / ADT curve
7 pN / n curve
8 «Scroll down» key
9 «Scroll up» key
3. Navigate through the submenus by additional clicks in the display.
4. Click «Scroll up» 9 to start the upward scroll.
Data
not visible prior to the scroll action are now displayed.
5. Click «Scroll down» 8 to start the downward scroll.
6. To move back between the menus, click «esc» as often as required.
7.3.3 Display graphs
When starting this menu, the recorded data from the last 60 minutes are loaded. The last 20 mi‐
nutes are displayed in a graph. The system updates the graph every ten seconds whilst the current
time is displayed.
Moving the mouse pointer across the graph calls up a ruler. The time selected with the ruler and
the associated values are displayed in the legend above the graph. When the ruler is hidden, the
time and associated values are displayed at the right edge of the graph.
The following graphs can be displayed:
■ System pressure
■ Airend discharge temperature
■ Machine status
─ OFF
─ IDLE
─ LOAD
■ Speed
The display of the
Speed
is implemented only for machines with frequency converter.
Precondition KAESER CONNECT for SIGMA CONTROL 2 is displayed.
7 Initial Start-up
7.3 Using KAESER CONNECT
9_9450 03USE
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3
51
To Next Page