KAESER ESD.2C - Assigning an Input

3. Press «UP».
8 9 p s i 0 8 : 1 5 1 7 6 ° F
5.5 Acknowledgement
Menu
Remote mode : Key+RC
Key remote : ☑
Active line with activated check box for the Remote
control key
·········
RC ack DI 1.11 ☐
4. Press «Enter» to accept the setting.
Result The «Remote control» key is activated.
7.12.4 Assigning an input
1. Press «DOWN» repeatedly until the active line is displayed.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
5.5 Acknowledgement
Menu
Remote mode : Key+RC
Key remote : ☑
·········
RC ack DI 1.11 ☐
Active line
2. Press «Enter».
DI flashes.
3. Use «UP» to select the desired input.
4. Press «Enter» to accept the setting.
The input has now been assigned.
5. Press the «Right» key.
6. Press «Enter» to switch into setting mode.
The check box for input will flash.
7. Press «UP».
7 Initial Start-up
7.12 Activating remote acknowledgement
9_9450 03USE
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3
135