KAESER ESD.2C - Configure and Activate the Email Function

2. Press «DOWN» twice.
E-mail submenu line is displayed as being active.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
8.1 Ethernet
Menu
▶1 IP configuration
▶2 Connections
▶3 E-mail
Active line, submenu email
Configure and activate the email function
Precondition Password level 2 is activated.
E-mail submenu is displayed as being active.
1. Press «Enter».
The display shows Email function as the active line.
2. Press «Enter» to switch into setting mode.
The check box for the email function flashes.
3. Press «UP» to deactivate the email function.
4. Press «Enter» to accept the setting.
The email function is deactivated.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
8.1.3 E-mail
Menu
active: ☐
Active line; deactivate/activate email function
Compressor number: 1
Language: Deutsch
Setting the language
------------------------------
Sender address:
status-kaeser@mdex.de
5. Set:
■ Compressor number
■ Language
■ Sender address
■ Sender's name
■ Telephone number of contact person
■ Recipient address
■ SMTP server:
─ Username
─ Password
6. Reactivate the email function.
7. Press «Escape» repeatedly to return to the main menu.
7 Initial Start-up
7.10 Configuring email
122
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3 9_9450 03USE