KAESER ESD.2C - Setting the Maintenance Interval

Message Meaning
0094 O
T-Switch ADT
0095 O
p-Switch pN
0200 O
IOSlot1 Undervoltage error 50
The internal voltage monitoring reports low voltage fault IOSlot1
0201 O
IOSlot2 Undervoltage error 50
The internal voltage monitoring reports low voltage fault IOSlot2
0202 O
IOSlot3 Undervoltage error 50
The internal voltage monitoring reports low voltage fault IOSlot3
0203 O
IOSlot4 Undervoltage error 50
The internal voltage monitoring reports low voltage fault IOSlot4
0204 O
IOSlot5 Undervoltage error 50
The internal voltage monitoring reports low voltage fault IOSlot5
0205 O
IOSlot6 Undervoltage error 50
The internal voltage monitoring reports low voltage fault IOSlot6
Tab. 76 Operational messages
8.9 Setting the maintenance interval
Example: Changing the oil change service interval.
Precondition Password level 2 is activated.
The display shows the operating mode.
Select menu “ Maintenance ”
1. Press «Enter».
The main menu is displayed.
2. Select < Maintenance > .
The maintenance interval “Oil filter” is displayed as the active line.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
4 Maintenance
Oil filter
Active line, description of maintenance interval
3000 h ¦ 0150 h Reset: ☐
Preset interval 3000 h
·········
Oil separator
3000 h ¦ 0150 h Reset: ☐
·········
8 Operation
8.9 Setting the maintenance interval
9_9450 03USE
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3
151