KAESER ESD.2C - Extinguishing Substances; Treating Injuries from Handling Cooling Oil

➤ Shut off supply lines if possible.
Mains disconnecting device (all poles)
Cooling water (if present)
Heat recovery (if present)
➤ Warn and move endangered personnel to safety.
➤ Help incapacitated persons.
➤ Close the door(s).
➤ When trained accordingly: Attempt to extinguish the fire.
Extinguishing substances
➤ Suitable extinguishing media:
Foam
Carbon dioxide
Sand or soil
➤ Unsuitable extinguishing media:
Strong jet of water
3.8.2 Treating injuries from handling cooling oil
Eye contact:
Cooling oil can cause irritation.
➤ Rinse open eyes thoroughly for a few minutes under running water.
➤ Seek medical help if irritation persists.
Skin contact:
Cooling oil may irritate after prolonged contact.
➤ Wash thoroughly with skin cleaner, then with soap and water.
➤ Contaminated clothing should be dry-cleaned before reuse.
Inhalation:
Cooling oil mist may make breathing difficult.
➤ Clear air passages of oil mist.
➤ Seek medical help if difficulty with respiration continues.
Ingestion
➤ Wash out the mouth immediately.
➤ Do not induce vomiting.
➤ Seek medical aid.
3.9 Warranty
This service manual contains no independent warranty commitment. Our general terms and condi‐
tions apply with regard to warranty.
3 Safety and Responsibility
3.9 Warranty
24
Service Manual Screw Compressor
ESD 442/14 bar (abs) SFC SIGMA CONTROL 2 ESD_2C_10357405_10–LIN_00 E