If you have noted your user name and stored it in a suitable location, you can now generate a
password on the SIGMA CONTROL 2. Note this generated password as well, and store it in a suit‐
able location. If your Equipment Card is damaged or lost, you can use these two to manually log
onto the SIGMA CONTROL 2 without an Equipment Card.
Precondition The customer is logged on with the Equipment Card
The display shows the operating mode.
1. Press «Enter».
The main menu is displayed.
2. Use the «DOWN» key to select the
<User>
menu.
The
Name
line is displayed as the active line.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
7 User
Menu
Name : E00019895
Active line, display of your Equipment Card's num‐
ber
Password: ****************
[Logout]
------------------------------
Current access level: 2
Display access level 2
3. Press «DOWN» twice.
[Logout]
is displayed as the active line.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
7 User
Menu
Name : E00019895
Password: ****************
[Logout]
Active line
------------------------------
Current access level: 2
Display access level 2
4. Press «Enter».
[Login]
is displayed as the active line.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
7 User
Menu
Name : E00019895
Password: ****************
[Login]
Active line
------------------------------
Current access level: 0
Display access level 0
7 Initial Start-up
7.2 Configuring the controller
9_9450 03USE
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3
39
To Next Page
Loading...
