Keithley 4200-SCS User Manual

4200-900-01 Rev. K / February 2017 Return to Section Topics 2-25
Model 4200-SCS User’s Manual Section 2: Model 4200-SCS Software Environment
Default user director: C:\S4200\kiuser
By default, all of the sample projects and standard libraries included with KTE Interactive are
stored in the C:\S4200\kiuser directory, as illustrated in Figure 2-15. This folder, is referred to
as the “default user directory.”
Figure 2-15
Default user directory
Note however, that KITE projects, device libraries, and test libraries can be stored and shared on
any accessible disk drive, including a network drive (except CD, CD-R, CD-RW drives and
write-protected drives or directories).
The default user directory contains several subdirectories. Each of these subdirectories is
discussed below under a separate heading.
Devices subdirectory
By default, the Devices subdirectory contains the KITE Device Library that is provided with each
version of KTE Interactive. Also by default, you can access this Device Library when operating
KITE. You can copy devices from this library to their projects or submit devices from their projects
to this library.
NOTE For more information about submitting devices to libraries, refer to the Reference
Manual, Submitting devices, ITMs, and UTMs to libraries, page 6-148.
Default user directory

Keithley 4200-SCS Specifications

General

Brand	Keithley
Model	4200-SCS
Category	Semiconductors
Language	English