Keithley 4200-SCS User Manual

2-48 Return to Section Topics 4200-900-01 Rev. K / February 2017
Section 2: Model 4200-SCS Software Environment Model 4200-SCS User’s Manual
Submitting tests to a library
You may submit one or more ITMs or UTMs to any test library if you submit them with names that
do not duplicate test names that are already in the library.
NOTE Before submitting any UTM to a library, make sure that it is configured. If you try to
submit an unconfigured UTM, KITE displays the message shown in Figure 2-38.
Figure 2-38
Unconfigured UTM message
To submit the UTMs or ITMs (for simplicity, these will be referred to as “tests” for the rest of
this topic):
1. In the project navigator, locate the device plan that contains the test or tests that you wish to
submit. Figure 2-39 shows an example device plan capacitor from an example u_build
project plan used in the Reference Manual, Building a completely new Project Plan, page 6-
48). The capacitor device plan contains the charg_char ITM to be submitted.
Figure 2-39
Device plan containing an ITM to be submitted
2. Double-click the device plan that contains the test or tests that you wish to submit. The
device plan window opens. See Figure 2-40.

Keithley 4200-SCS Specifications

General

Brand	Keithley
Model	4200-SCS
Category	Semiconductors
Language	English