Leibinger JET3 up - Page 111

Group 8 Job Editor Page 109
JET3up Release R1.06
15. The print job at the fif
th position of the job list shall be printed twice.
Therefore the address has not to be changed for the next print-out (13)
. It
will be printed again with the next <PrintGo> signal.
16. Apply the address of the print job at the first position of the job list t
o the
X4 connector (decimal=1; 10-bit binary=0000000001 (13).
17. With the next <PrintGo> signal the addressed print job will be printed.
18. The task is finished.
Basic rules for the job list type <External Job>:
 Each print job is managed separately.
 Each print job needs a <PrintGo> signal to be printed.
 A single print job of the <External Job> job list can be edited
directly in the
joblist editor. A click on the <Job edit>
button will open the currently
selected print job in the <Job Editor>. After changes are saved in the
<job
editor> leave the <Job Editor> with the <Close>
in order to return to the
joblist editor.
 <PrintGo distance>, <PrintGo repetition> and the option for <endless>
printing have to be set within the single print jobs.
 An empty address will
be ignored. The last addressed print job will remain in
the print storage.

The WYSIWYG preview of the main window always shows the print job that
will be printed with the next <PrintGo> signal (14).